Bambu Lab X1-Carbon 3D Printer User Manual
Component Introduction
Accessory Specification
Tool Head Unlock
Remove the cardboard from the tool head. Remove the foam from the excess chute.
Cut the zip tie securing the tool head.
Spool Holder Assembly
Remove the screw as pictured with an Allen Key H2.
Secure the spool holder with two screws from the accessory box.
*We recommend using the short end of the Allen Key to unlock the screws more easily.
Hot Bed Unlock & Screen Installation
Remove the three screws with an Allen Key H2 to unlock the hotbed.
Pull the Flexible Printed Circuit (FPC) out about 50mm.
Insert the FPC into the port by pressing the terminal as pictured.
Insert the screen back into the slot on the printer, then lock it by pushing it to the left.
Printer Binding
- Download the Bambu Handy App. Register and log in your Bambu Lab account.
- Connect the printer to power. Follow the instructions on the screen until getting to the page shown on the right side.
- Use Bambu Handy to scan the QR code on the screen, and bind your printer with your Bambu Lab account.
Bambu Studio
Download Bambu Studio: http://bambulab.com/download
Log in to Bambu Studio with your Bambu Lab account, which is the same for the Bambu Online store. Create or open a project.
Slice the model, select your printer, and send the model to print. *We recommend performing bed leveling before each print and performing flow calibration after changing the filament.
“Device internal, you can remotely monitor your print, or pause/stop printing on the *The live view can be seen only if a camera is mounted.
Specification
