Table of contents
show
RAM Mounts RAPSB187GA41 Garmin Mount User Manual
Parts Index
- Attach (C) adhesive rubber pad to (B) strap
- Cut out the measuring strip shown on the right. Wrap the strip around the area where RAM® EZ-Strap is to be attached until the “ALIGN EDGE ™ WITH ZONE” end aligns with one of the “Short, Medium, or Long” segments to determine the appropriate strap length. Once the correct segment is determined, use scissors to cut only along one of the shown reference lines “…. ” just past the corresponding groove.
- With (C) adhesive pad facing up, insert (D) pin halfway inside the hinge of (B) strap. Insert (B) strap with protruding (D) pin into the backside right slot of (A) base. While pressing the (B) strap firm against the (A) base, press the pin through the left slot using a flathead screwdriver. Adhere (E) adhesive pad.
- Place RAM on the surface and feed the strap through ® EZ-Strap™ (A) base until the strap clicks into the base. Hold the RAM® EZ-Strap in ™ place as you pull the strap to tighten.
To see more mounting options, visit rammount.com This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.
