LifeSmart SG160 Tabletop Gas Griddle User Manual

LifeSmart SG160 Tabletop Gas Griddle User Manual

PRECAUTIONS:

1. Do not operate Griddle any closer than 36 inches from any combustible construction, including walls and ceilings. Never use indoors.
2. Do not use this appliance under overhead combustible surfaces.
3. If this regulator fails, it must be replaced with the exact model. Please call customer service for a authorized replacement part.
4. Perform a visual inspection of the gas path, from the leaks, cracks or intrusions. Begin at the tank and continue to the gas line connection. Visually inspect the knob mechanism for similar defects. Follow the gas path to the elements. Look for abnormalities or grill box. Please contact customer service with any questions or concerns.

WARNING:
It is the consumer’s responsibility to see that the Griddle is properly assembled, installed, and maintained. Failure to follow the instructions in this manual could result in bodily injury and/or property damage.

Safety Maintenance

•  Keep appliance area clear and free from combustible liquids.
• Keep the ventilation opening of the cylinder enclosure free and clear from debris.
•  Clean appliance, including special surfaces, with recommended cleaning agents, if necessary.
• Check and clean burner/venturi tube for insects and the appliance.

USE

Safety Tips

1. When Griddle is not in use, turn the Griddle off.
2.  Never move Griddle while in operation or still hot.
3.  Use long-handled barbecue utensils and oven mitts to avoid burns and splatters.
4.  Keep unit at least 36” away from walls, buildings, vehicles or other structures when in use.
5.  Clean Griddle often, preferably after each cookout.
6.  If you notice grease or other hot material dripping from griddle onto the valve or regulator, turn off gas supply at once. Determine the cause, correct it, then clean and inspect valve, hose and regulator before continuing. Perform a leak test.

Turning Griddle OFF

Turn knob to the OFF position.

Valve Check

Important: knob should spring back. If knob does not spring back, replace valve assembly before using the 17” Griddle. Turn knob to low position then turn back to OFF position. Valve should turn smoothly.

Care

General Griddle Cleaning

•  Do not mistake brown or black accumulation of grease and smoke for paint. Do not apply a caustic griddle/ oven cleaner to painted surfaces.
•  Plastic parts: Wash with warm soapy water and wipe dry. Do not use Citrisol, abrasive cleaners, degreasers or a concentrated oven cleaner on plastic parts. Damage to and failure of parts can result.
•  Painted surfaces: Wash with mild detergent or nonabrasive cleaner and warm soapy water. Wipe dry with a soft nonabrasive cloth.
•  Baked-on grease deposits may require the use of an abrasive plastic cleaning pad. Use only in direction of pad on areas with graphics.

Storing Your Griddle

•  Store in dry location.
• When an LP bottle is connected to Griddle, store outdoors in a well-ventilated space and out of reach of children.
•  Store Griddle indoors ONLY if LP bottle is turned off and disconnected, removed from Griddle and stored outdoors.
• When removing Griddle from storage, follow “Cleaning the Burner Assembly” instructions before starting griddle.

Cleaning The Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting griddle

1.  Turn gas OFF at control knob.
2.  Detach electrode from burner.
3.  Carefully lift burner up and away from valve openings.We suggest three ways to clean the burner tubes. Use
   the one easiest for you.
4.  Wire brush entire outer surface of burner to remove food residue and dirt.
5.  Clean any blocked ports with a stiff wire such as an open paper clip.
6. Check burner for damage, due to normal wear and corrosion some holes may become enlarged. If any large cracks or holes are found replace burner.

ASSEMBLY AND LIGHTING INSTRUCTIONS

Please read all instructions thoroughly before proceeding. Find a large, clean area in which to assemble your Griddle. Please refer to the assembly diagram as necessary.

PARTS LIST

• (4) Adjustable Height Feet
• Oil Drip Tray
• Main Body
• Regulator

STEP 1
Remove the four adjustable height feet and regulator from the packaging and place on a flat soft surface upside down. Attach the four adjustable height legs to the bottom of the grill. Flip the griddle over and align the the griddle pan to the body.

STEP 2
Screw in the LP bottle into the gas regulator, turning the tank clockwise

The LP bottle should look like the picture below when properly connected to the regulator.

STEP 3
Insert the gas regulator and tank into the gas line of the griddle. Turn the collar of the gas regulator clockwise to secure it to the gas line.

CUSTOMER NOTICE: To perform a leak test of your gas connections, mix a 50/50 solution of soap and water and brush around regulator and other gas connections. If growing bubbles appear, there is a leak. Re-tighten connections. If leaks cannot be stopped do not try to repair.

STEPS 4:
Attached the oil drip tray on the back of the griddle.

Match Lighting Instructions
Do not lean over the Griddle while lighting. Make sure there are no gas leaks.

1. Ensure the control knob is in the”OFF”position.
2.  Remove the griddle top.
3.  Light an 11″ long match, then place the match on the right or left side of the burner.
4. Push in and turn the control knob to the HIGH position. Be sure burner lights and stays lit.

Ignition Needle Placement
The ignition needle should be 3-7 millimeters from the burner tube to create the proper spark. The ignition needle should not touch the burner tube.

Oil Drip Tray
Check the oil drip tray often and clean out after each use.

CARE, MAINTENANCE

Regularly clean your Griddle between uses and especially after extended periods of storage. Never handle hot parts with unprotected hands. In order to extend and maintain the life and condition of your Griddle, we strongly recommend that the unit be covered when left outside for any length of time, especially during the winter months.

Fittings and Storage
Store the Griddle in a cool dry place. Cover the burners with aluminum foil in order to prevent insects or other debris from collecting in the burner holes. If the Griddle is to be stored indoors, the gas bottle must be disconnected
and left outside. The gas bottle should always be stored outside, out of reach of children, and in a dry, well ventilated area away from any sources of heat or ignition.

Troubleshooting

ONE-YEAR LIMITED WARRANTY

The manufacturer warrants this heater against defects in materials and workmanship on functional parts, for a period of 1 year from the original date of purchase. Your sales receipt showing the date of purchase of the product is your proof of purchase. Keep it in a safe place for future reference. This warranty is subject to personal use only, commercial or rental applications will not be covered. This product is made with the highest quality materials and is warranted to be free from defects in materials and workmanship at the time of purchase. This limited warranty applies to products manufactured or distributed by the manufacturer, are delivered in the continental United States or Canada and extends to the original purchaser, or gift recipient.

REFERENCE LINK

https://iot.ilifesmart.com/