Table of contents
show
SWANN Wireless Door Chime with Mains Power User Manual
OVERVIEW
SETUP
Installing the Chime Speaker
No wiring is necessary. Just plug the Chime Speaker into an easily accessible power point and switch the power point on.
Installing the Doorbell
The Doorbell comes pre-paired with the Chime Speaker. Simply install the supplied “23 A/12V” battery and it’s ready to use.
- Insert a small flat-head screwdriver into the small notch at the base of the Doorbell and carefully remove the rear cover.
- Fit the “23 A/12V” battery into the battery compartment according to the polarity markings (+ and -) shown.
- Turn the Doorbell over and press the button. The Doorbell LED illuminates for 2 seconds and the Chime Speaker responds with the default chime. If the Doorbell LED does not come on, check that the battery is fitted correctly, and test again.
- Replace the rear cover with the UP arrow oriented pointing up.
Mounting the Doorbell
The Doorbell can be mounted by sticking it to a wall with the supplied double-sided adhesive tape. The operating distance between the Chime Speaker and Doorbell is up to 50 m/165 ft but the range may vary depending on local conditions.
OPERATING BASICS
Adjusting volume
Changing chimes
- Cycle through the sounds available on the Chime Speaker.
- Stop when you hear something you like.
- There is no need to confirm your selection
Pairing with the Chime Speaker
- Make sure the chime is not playing then press and hold this button for 5 seconds. You will hear the current
chime playing followed by a double beep. - Press the Doorbell button within 10 seconds. The Chime Speaker beeps once to confirm successful pairing. The pairing process ends when you hear a double beep.
Resetting the Chime Speaker
- Switch the power point off and unplug the Chime Speaker.
- Press and hold this button. As you are holding the button, plug the Chime Speaker back in and switch the power point on. Keep holding the button until the Chime Speaker blinks twice. After you reset the Chime Speaker, you need to pair the Doorbell again
