TRIBIT XSound Go TS-BTS20 User Manual
Safety instructions
- Avoid dropping.
- Not disassemble.
- Avoid extremes temperatures.
- Do not use the device outdoors during thunderstorms.
- Do not use any corrosive cleaner/oil to clean.
Specification
- Bluetooth version: V5.0
- Support: A2DP, AVRCP, HFP, HSP Output power: 2 x SW
- Battery: 3. 7V, 4400mAh
- charge time: 5 hour Input: DC5V/1A
- Dimension: 175 x 59 x 56 (mm) Weight: 380g
What’s in the box
Connections
Bluetooth connection
Stereo Mode
- Make sure both speakers are on
- On press * one of the speakers to enter pairing state.
- Press * on the other speaker for 5s, then release the button to enter Stereo pairing when you hear the “Stereo mode”. When you hear “Left chanel” on the left speaker and “Right chanel” on the right speaker, the “Stereo mode” is on.
Buttons
| Button | Operation & Function |
| Power on/off | turn on/off Press |
| Bluetooth | enter pairing mode |
| Volume+ | increase the volume level |
| Volume – | decrease the volume level |
| Play/Pause | • play/pause Music and answer/end call • Long press to reject a call • twice to skip to next track •triple to skip to Previous track |
Indicator
| Indicator | Status |
| flashes slowly Blue indicator | Reconnection mode |
| Blue flashes quickly indicator | pairing Bluetooth mode |
| Blue indicator keeps on | Pairing has been successfu |
| Red indicator flashes slowly | Low battery power (<15%), charge the speaker as required |
Reset
If this speaker has some problem, you can try to press and hold “Volume +” and “Volume -” button simultaneously for 5 seconds to reset, and then pairing again (delete the old pairing in your device).
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment hos been tested and found to comply with the limits for a Closes B digital device, pursuant to Port 15 of the FCC Rules. These limits ore designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which con be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into on outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
