Shark IZ1441H Vertex Ultra Lightweight Cordless Stick Manual
WHAT’S INSIDE:
- A Handheld Vacuum
- B MultiFLEX® Wand
- C DuoClean® PowerFins Floor Nozzle
- D Crevice Tool
- E Pet Multi-Tool
- F Anti-Allergen Brush
- G Lithium-Ion Battery (Pre-Installed)
- H Charger
- I HEPA Post-Motor Filter (Pre-Installed)
For additional parts and accessories, visit sharkclean.com POWER SETTINGS.
REACH ANYWHERE
Press the MultiFLEX® Lock Release button to lower the angle of the wand to increase your reach.
STORE ANYWHERE
Press the MultiFLEX Lock Release button and fold the handheld vacuum forward. To vacuum, lift up the handheld vacuum, until the wand locks in place.
EMPTYING THE DUST CUP
- To empty the dust cup, first disconnect the handheld vacuum from the wand by pressing the Wand Release button and pulling it up on the handheld vacuum.
- Position the dust cup over a trash bin and slide the lid release button forward.
POWER SETTINGS
OFF
Slide the switch to the top to turn off the power. To begin vacuuming, slide the switch to the appropriate setting.
HARD FLOOR SETTING
Slide switch to the middle. The brush rolls spin slowly to clean hard floors and low-pile area rugs.
CARPET SETTING
BOOST MODE
For an added boost in power, pull the Trigger on the handheld vacuum. Release it to return to standard power.
LITHIUM-ION POW
Charging
Battery Indicator Lights
NOTE:
The Lithium-Ion Power Pack battery comes partially charged. Charge fully before first use, then run the battery down until it is completely out of power. This will condition the battery so the LED indicators will work properly.
CHARGING
To put the vacuum in storage mode, press the MultiFLEX Lock Release button while folding the handheld vacuum forward until the wand clicks and locks. Plug the charger into the charging port on the battery.
To remove the battery, press the Battery Release button and slide out the battery. Plug the charger into the charging port on the battery.
REFERENCE LINK
DOWNLOAD LINK
Shark IZ1441H Vertex Ultra Lightweight Cordless Stick Manual
