Snail ax MT761 Steam Foot Spa Massager manual

Snail ax MT761 Steam Foot Spa Massager manual

Safety Precautions

Please read carefully all instructions before using the product. This instruction helps you to use the product safely and correctly to avoid any injury or property loss.

Please follow the relevant provisions of the safety precautions

ATTENTION: Avoid any potentially dangerous situation, otherwise, it may cause severe hurt or property loss.

WARNING!

1. People who are insensitive to heat must be accompanied by normal person when using this device. Otherwise, it may cause burns.
2. Please use this product only for a foot massage, do not use for medical purposes or commercial use.
3.  Please stop using it immediately if you feel pain or abnormality on your skin or body.

The following people should not use this product.

•  Women during pregnancy or menstruation.(It may cause skin problems due to hormone imbalance.)
• People with allergies.
• People with skin diseases, atopic dermatitis,  or sensitive skin.
• People with skin problems, including dermatitis and severe sunburn.
• People with skin damage, eczema, swelling, etc.
• There is a possibility of causing skin and physical discomfort

ATTENTION!

1. When emptying the remaining water in the water box after use, please hold the appliance to prevent hot water from spilling on your hands. Pay attention to the high temperature of the water removal box after use. Otherwise, it may cause burns.
2. Use only distilled or purified water. Otherwise, it may cause equipment failure, and it may cause burns in severe cases.

•  Do not pour hot water above 50 ℃ to avoid scalding the skin and damaging the product
•  Do not use it for therapeutic purposes.
• This product is limited to one person, please do not use two or more people at the same time.
• Do not use this product while drunk or unwell.
• Do not use it immediately after meals to avoid discomfort.
• Do not wear ornaments on the feet when using the product.
• Do stop using it immediately and consult a doctor if you feel any discomfort during the use.
• Do not fall asleep while the product is working.
• It is recommended to use 30 ~ 40 minutes each time.
• Do not sit on the product to avoid injury or damage to the product.
• In winter, please empty the water inside of the product after use to avoid freezing the parts.
• The product should be cleaned immediately after use to avoid skin disease infection when used by others.
• Do not drag the product on the ground or pull the power cord to move the product, which may damage the product.

Warning about skin:

• Excessive use may damage the skin. In the beginning, this product can only be used once a day, 2 to 3 times a
  week. After about a month, this product can be used once a day. Please adjust the frequency and �me of use according to your skin condition.
• If skin problems occur while using the product, please stop using it.
• Basic skincare is required after using the product. If you do not do skincare after using it, it may cause moisture in the skin to evaporate easily, resulting in dry skin.

Product Parts

1. Control panel
2. Add water tank
3. Drain key
4. Waste water box
5. Wire storage device
6. Power plug
7. Soft foot pad
8. Flexible cover
9. Steam outlet
10. Water leak
11. Add water cover
12. Acupuncture
13. Foot bath bag position
14. Electric Kneading
15. Roller

NOTE:

This product has undergone a strict water operation test before the package. There may have little water droplets in the appliance, which will not cause any health problems.

Preparation

Place the product on a flat surface

• When using, place the body on a flat, solid  surface such as the floor.
• When the product body is tilted, the water in the water tank cannot supply water to the product, therefore, steam cannot be
  released.

Take out the water tank from the product.

• Press firmly on the water tank (image A), and when it pops out, pull out the water tank (image B).

Turn and open the water tank cover

Pour water into the water tank (image C), and then gotten the water tank cover.

• If the water tank is filled, the steam lasts about 35 minutes.

Install the water tank to the product (image D).

• Put the water tank into the product body until it has a click sound.
• When the water tank is installed into the product body, it will supply water for the product and the water in the water tank will
  decrease.

Attention!

• Do not add water repeatedly to the appliance. Add water until the water indicator flash.
• Do not let foreign objects such as dust or dander into the water tank.

Use only distilled or purified water.

Due to different water quality, it may shorten the lifespan of this product.
Therefore, we recommend to use distilled or purified water. They are generally available in supermarkets.

The following types of water cannot be used because they contain high minerals.

• Tap water
•  Geothermal water
• Groundwater
• Mineral water
• Acidic water
• Ionized alkaline water

Do not incorporate any other substances.

Do not mix any other substances into the water, such as lotion, aromatic oil, etc.. Otherwise, it may cause burns, malfunction or shorten the lifespan of the product.

How to use

Insert the power plug of the product into a household power outlet.

• When the amount of remaining water is insufficient, the steam release method will change. This is not a malfunction.
•  If the water in the water tank is used out, steam will be stopped. Please add water in �me. Please unplug the power plug if not in use.

Press the power button on the operation panel to start the massage.

• This product is controlled by touch keys, and can be operated by touching the position of each symbol on the keys (except the water indicator).

ATTENTION!

•  Do not hold down the buttons for a long time to avoid malfunctions.
•  Do not operate the control panel with wet hands or splash water on the control panel, otherwise it will cause a fail function.

Power Button

Startup: Press it to turn on the product in standby mode. The default setting is [Rolling Massage-Low Level] [Heat -Low Level] [Timer – 10 minutes]; The corresponding indicator in the panel will be on.
Stop: Press it to turn off the machine during working mode; When the timer expires, all massage actions and heating functions will be stopped and enter into standby mode.

Heat Button

There are three levels heat temperature to choose, which can adjust the suitable temperature. Pressing different buttons to choose desire temperature, and the corresponding light indicator is on. (The fan continues to work for 30 seconds after turning off the heat function.

Rolling Button

The default is low-speed rolling massage speed with green light indicator is on; press the button again to turn the massage speed to high speed, the red light is on; press the button again, the rolling massage function stops and the two-color light turns off.

Timer Button

The default time is 10 minutes. During the timing, press the corresponding 10 minutes or 20 minutes button, and the time will be re-timed. When the time expires, the product is in the standby condition.

Lack of Water Indicator

When the water tank is lack of water, the heat function cannot be turned on and the buzzer sounds to remind of adding water. The indicator of water will flash 30 seconds and then be off.

• When the amount of remaining water is insufficient, the steam release method will change. This is not a malfunction.
• If the water in the water tank is used out, steam will be stopped. Please add water in time. Please unplug the power plug if not in use.

Foot bath bag

When using a foot bath bag, please open the cover of the foot bath bag position, and then place the bundled foot bath bag in the box.

ATTENTION!

•  In order to prevent the solid materials from blocking the pipe, be sure to use a bag or a hand-gitterned bath bag to avoid blocking the leak.
• After use, please take out the bath bag and clean the foot pedal.

After use

1.  Press the power button on the control panel to turn off all functions.
2.  Unplug the power plug from the household power socket (image ①).
3. Press and hold the drain key (image ②) to drain the water in the water tank.                                                                                                 
4.  Pull out the waste water box from the product (image ③), and pour out the remaining water. Please pour out the
   remaining water in the water tank to ensure the product is clean. Otherwise, water marks or odors may be generated. While pressing the drain key, pay attention to the water volume of the waste water box to prevent overflow.
5.  Pour out the water in the waste water box (image ④). Otherwise, water marks or odors may be generated. When pouring
   water, hold the waste water box and avoid contact with hot water, otherwise, it may cause burns.                                                                             
6. Install the waste water box (image ⑤). Push the waste water box into the product until it clicks.
7.  Clean the foot pedal (image ⑥). Take the foot pedal out of the product and wash it with clean water.
8.  Wipe the water above the product body.

Clean

Clean the inside of the product

• Clean once a month.
• In order to remove and prevent scale deposits, the appliance should be allowed to cool for at least 10 minutes after use, and then cleaned according to the following steps.

Wipe the water from the body and water tank.

• Even after draining, there will still be remaining water in the appliance. This will not cause hygiene problems because the water will be boiled when the next time use.

Clean the product body

Do not wash or soak the product body in water.

• Use a cloth dampened with soapy water to wipe the product body.
• Never use alcohol, thinner, benzine or nail polish remover. Those material may cause product malfunction or cracking or discoloration.

Clean the power cord set

•  Clean once a month.
• Unplug the power plug from the household power outlet, and wipe off dust, etc. with a dry cloth.

What if the add water cover’ seal ring fall out

1.  Put the sealing column into the spring, and push the index finger into the central part of the water filling cap.
2.  Gently press the outer edge of the water-filling cap seal(A), find the recessed hole under the water-filling seal ring(B), keep the sealing column floating, and insert the seal ring to make the recessed holes match.

Specification

This product is only for home use.

FAQ

If above treatment did not solve the problem, please contact customer service.

Emergency treatment

If any abnormal occurs (scorched smell, etc.), stop using the product immediately and unplug the power plug.

•  If you continue to use it in an abnormal condition, it may cause fire and electric shock due to heat, etc., please contact the customer service immediately.
• If the red indicator light of the power supply stays on for more than 3 seconds, the product automatically enters the shutdown condition. This is an abnormality in the appliance. Please stop using it immediately, unplug the power plug, and contact our customer service.

Warranty

If you have any issue about the product, please feel free to contact us by sending email to support@snailax.com We will strive to provide the best service possible within 24 hours.

30 days unconditionally Return

Snail ax product can be returned to receive a full refund for any reason within 30 days. Please contact our customers service (support@snailax.com), our staff will contact you within 24 hours.

90 days refund/replace

Snail ax product can be returned / replaced within 90 days if the product break down in the period of proper use.

12 months Warranty

If the product break down within 12 months in the period of proper use, customers can enjoy the relevant warranty to get them replaced.

Attention!
No warranty will be given to any force majeure and man-made causes to a defective product, such as improper care, personal tear down and willful damage, etc.

Extend Warranty for Free

1) Enter the following URL or scan the QR code below to find Snail ax Facebook page and like it, enter “Warranty” to messenger to extend your warranty from 1 year to 3 years.

https://www.facebook.com/snailax

OR 2) Send message “Warranty” and email us support@snailax.com to extend your warranty from 1 year to 3 years.

Have question?

Tel: 734-709-6982
Monday-Friday 9:00AM-4:30PM
Email: support@snailax.com

REFERENCE

https://cdn.shopify.com/s/files/1/2502/3672/files/SL-MT761_user_manual_2022.07.07.pdf?v=1664348979